Timberwolf TW 230HB, Инструкция по эксплуатации, Страница: 58 / 64

9.5 12-Monthly Storage Checks
1. Carry out all 3-monthly and all 6-monthly checks.
2. Inspect the bearing lubrication system for the presence of water. If water is detected,
flush out the bearing housing and re-lubricate immediately.
9.6 Recommissioning after Storage
1. Ensure the chipper is stable. (Section 4.4 " Stabilising the Chipper" on page 23.)
2. Remove all guards and check all fasteners. ( Section 6.7 " Check and Replace
Fasteners" on page 40.)
3. Ensure the discharge tube is greased ( Section 6.14 " Grease the Discharge Tube
Mounting Flanges" on page 47), fastened, free of blockages, rotates through its full
range of movement and cannot face the operators working position.
4. Ensure the feed funnel is free from foreign objects (e.g. tools or clothing).
5. Open and close the feed tray to ensure it operates correctly.
6. Check fuel, engine oil and hydraulic fluid levels and top up as required. *
7. Inspect all internal parts (e.g. drive belts, taper locks and shaft key-ways).
8. Check belt tension. (Section 6.9 "
Adjust Rotor Drive Belt Tension" on page 43 and
Section 6.10 " Adjust Hydraulic Pump Drive Belt Tension" on page 43.)
9. Inspect the cutting blades to ensure they are sharp and suitable for use.
10. Refit all guards.
Before reconnecting the battery cables ensure that the machine is in a well-ventilated
area and that any fuel fumes have been allowed to dissipat.
11. Connect the battery cables. (Section 6.6 " Battery Safety Information" on page 38.)
12. Carry out an electrical diagnostic continuity check, to ensure the circuit is complete.
13. Check and restore the tyre pressures.
14. Lubricate all grease pipes. Remove pipes and bleed the system prior to use, if
necessary. *
15. Carry out normal daily checks before starting. (Section 5.6 " Checks Before Starting" on
page 28.)
16. Start the engine.
17. Run for 15 minutes at half throttle, to clear the engine.
18. Run for a further 5 minutes at full throttle, prior to any cutting activity.
* Storage fluids and greases should be replaced. DO NOT use old fluids or greases.
56/61 C190-0304 - Rev 1.0 EN
TW 230HB (Petrol) 9 Storage