Timberwolf TW 230HB (Diesel), Инструкция по эксплуатации, Страница: 27 / 62

C190-0302 - Rev 1.0 EN 25/59
5 Operating Instructions
WARNING
DO NOT USE OR ATTEMPT TO START THE CHIPPER WITHOUT
THE PROTECTIVE GUARDING AND DISCHARGE TUBE
SECURELY IN PLACE. FAILURE TO DO SO MAY RESULT IN
PERSONAL INJURY OR LOSS OF LIFE.
5.1 Manual Controls
Manual controls are located on the feed tray,
where they are easily accessible by the operator
during chipping.
Infeed Control Boxes
A control box is located on either side of the feed
tray, containing two controls (Figure 4, Item 2).
Figure 4 - Manual Control Positions
Forward Feed Control (Figure 5)
Press the GREEN control to start the in-feed
rollers turning in the forward direction, if the
engine speed is high enough (Refer to Section
5.2 "
No Stress Control" on page 26). This allows
you to feed material into the chipper.
When the control is released, the in-feed rollers
will continue to turn.
Figure 5 - Forward Feed Control
Reverse Feed Control (Figure 6)
Press the BLUE control to reverse the direction
of the in-feed rollers. This allows you to back
material out of the chipper.
The in-feed rollers will only operate in reverse
while the control is held in.
Figure 6 - Reverse Feed Control
TW 230HB (Diesel)