Timberk THU UL 23 E, Инструкция по эксплуатации

Страница: 6 / 28

www.timberk.com • ultrasonic humidifier
6
«Filling the reservoir with water», then connect the device to the
electrical network.
Aroma
The device is equipped with aroma capsules. When you add
aromatic oil to it, air is aromatized. Aromatic oil is not included
in the scope of supply.
Switching off the device
To turn off the device, press the button on the control panel
several times, the device will turn off, and the indicator on the
control panel will turn off.
Before cleaning the device make sure that the plug is
disconnected from the wall outlet. Otherwise, it may result in
electric shock. Before cleaning, wait until the cooling water in the
ground, so as not to burn your hands. Spend device cleaning
once or twice a week. To clean the outer surface of the unit with
a damp soft cloth. To avoid electric shock, do not scratch or
damage the device while cleaning elements.
Do not use when cleaning the device thinner, benzene, dimethyl
benzene, stiff brush, talcum powder and other materials, except
water.
Wipe any remaining water inside the base with a damp, soft
cloth.
To remove the remaining water in the small details, you can use
a soft brush, then wipe it again with a soft cloth.
In the formation of dirt on the membrane, clean it with a soft
brushes. Use a soft brush to erase the remnants of water on the
surface of the device, and then wipe it again with a soft cloth.
Rinse water tank and a clean water dispenser.
After removal of the residual water from the surface of the
sprayer, wipe it with a soft cloth. Clean the outside surface with
a damp, soft cloth.
8. CLEANING AND MAINTENANCE
IMPORTANT!
To avoid deformation or wear of working
surfaces, resulting in decreased atomizing
or other malfunctions, do not use metallic
brushes, blades or talc powder to wipe the
atomizer’s surface. The water tank may
leak upon heavy impacts. In case of water
leakage, immediately stop using the unit and
contact a service center. To keep the unit dry,
remove water after cleaning and make sure
to dry the unit’s case. Make sure that there
is no water left inside the unit’s case. Prior to
a long break in using the unit, dry its surface
and pack it into a plastic bag, then put it into
a box. Store the unit in a low-humidity room.
Storing the unit undried results in generation
of mold.
In case of emergency, please, use the troubleshooting
methods shown in tables. If it is impossible to solve
problems with these methods, apply to the service center.
10. TROUBLESHOOTING