Timberk THU UL 16M, Инструкция по эксплуатации, Страница: 18 / 20

IM2020
18
10. TROUBLESHOOTING
Malfunction Possible cause Solution
Poor atomizing (insufficient
productivity)
The unit is operating in
the low atomizing mode (low
atomizing frequency)
It is not a malfunction. Switch the
device into the intensive mode of
operation
The atomizer is clogged Clean the atomizer.
Temperature of water in the
tank is low
Set maximum productivity mode.
The humidifier’s productivity will
go up after a while.
No atomizing
The power cord is poorly
connected to the outlet Connect the power cord into
the outlet carefully
There is white patches from the
water on objects around the
humidifier (salts, separating out
from water)
White patches have
formed on the membrane
Clean the humidifier’s membrane
with a special brush
There is a lot of salts in the water
(calcium and magnesium)
Use filtered water
Steam has a bad smell
Stale water is used Clean the unit according to
the cleaning and servicing
instructions and fill the tank
with fresh and filtered water
Remains of stale water or waste
have accumulated in the unit’s
case or the atomizer
During the operation of the
device, condensate is forming on
the upper part of the humidifier
and on surrounding objects
High humidification intensity is
set.
Decrease the humidification
intensity
Room humidity and
room temperature are high
During the operation of the device
water appears next to it
High humidification intensity is
set. Decrease the humidification
intensity
The water tank is badly installed
on the unit’s base and there is a
gap between them.
Turn off the unit and make sure
the water tank is installed
correctly on the base, without any
gaps between the tank and the
base.
White patches have formed on
the membrane and in grooves for
water (in the unit’s base). Clean the unit according to the
cleaning and servicing
instructions.
Water appears next to the
humidifier, when it is off
Water tank is leaking
Contact an
authorized service center
11. UTILIZATION RULES
After the lifetime of the device expires, it should be recycled in compliance with the laws, rules and
methods in region of recycling. Detailed information about the recycling of the device, you can
receive from a representative of the local authorities, after providing full information about the
device. The manufacturer and authorized organization of the manufacturer do not carry
responsibility for the fulfillment by the Buyer of the requirements of legislation on utilization and
methods of utilization of the device selected by the Buyer. The lifetime of the device is indicated in the
warranty card. Warranty period for the device and warranty terms are specified in the warranty card. The
warranty card is an integral part of the documentation supplied with this unit. If there is no warranty card in
the delivery set, ask for it from the Seller. The warranty card provided by the Seller must conform to the
manufacturer’s form.
The manufacturer and the authorized organization of the manufacturer remove responsibility for any possible
harm which can be caused to people, animals or property directly or indirectly, if this harm occurred as a
result of noncompliance with the rules and operating conditions, installation of the device, intentional or
reckless actions of the user- and / or third parties, as well as in situations caused by natural and / or
anthropogenic accidents.