Timberk THU MINI 01 (BL), Инструкция по эксплуатации

Страница: 5 / 16

ATTENTION!
To avoid deformation and abrasion of working surfaces, resulting in
lowering of diffusion level or other defects, do not use metal brushes,
razors or talc powder to wipe the nozzle surface.
In case of a heavy shock, the tank may leak.
In case of a water leak, stop the appliance operation immediately and
apply to the service center.
To keep the appliance dry, remove water after cleaning and dry the water
tank and the case.
Make sure that there is no water left within the water tank and the case.
Before a long pause in use of the appliance, please, dry the tank and the
surfaces, install the tank into the case and pack the humidifier in a plastic
bag, and then in a box. Keep the appliance in a room with low humidity.
Keeping of the appliance in undried condition may result in moldiness.
7. Appliance operation .
Switching on/off, control of steam escape intensity .
Plug the appliance. Before that, fill the tank with water.
Turn the on-and-off and steam escape intensity controller to the right.
The appliance will switch on, the indication light will flash and steam will
come out from the diffuser. In the very beginning of this operation the
diffusion level may be unstable, which is caused by temperature
difference and water quality. Stabilization of this process will take a short
time. Turning the controller to the right and to the left, you may control
the steam intensity. Higher intensity of steam escape results in stronger
and faster air humidification. Relative air humidity for comfortable
conditions should be between 40 and 60%. You may define a favourable
humidity level on the basis of your own feelings or use a special device -
hygrometer*, measuring a relative humidity level.
Attention!
Never remove a water tank and upper cover from the appliance in
operation, until there is at least some water in it. Otherwise, the water
level within the appliance will rise, which may result in breakage or
failure of the humidifier (steam will stop coming out). To resume work in
a case of breakdown, unplug the appliance and discharge the water.
Attention! Water should be discharged from the appliance only in the
direction of the diffuser beak (i.e. to the right, if looking at the on-and-
off controller).
8 . Cleaning and maintenance
Before cleaning of the appliance, please, make sure that it is unplugged.
Otherwise, it may result in electric shock.
Before cleaning, please, wait for complete cooling of water in grooves
to avoid burning your hands.
Clean the appliance once or twice a week.
7.1 Wipe an external surface of the appliance with wet and soft cloth.
To avoid the electric shock, do not s cratch and damage elements of the
appliance, while cleaning. Do not clean the appliance with solvent,
gasoline, xylene, scrub brush, talc powder and other substances, except
for water.
7.2 Wipe remaining water within the groove under the tank with wet
and soft cloth.
Water remaining on small components may be wiped by a soft brush. en
clean these components with soft cloth.
7.
3 If the membrane is dirty, clean it with a soft brush.
* not included in the delivery set.
7. 4 Use a soft brush to wipe remaining water on the nozzle surface and
then wipe it again with soft cloth.
7.
5 Wash the water tank and diffuser with pure water. Wash the cover
accurately and lightly. Otherwise, it will result in leaking of water
through the cover.
After removing of water from the diffuser surface, wipe it with soft cloth.
Clean the external surface of the appliance with wet and soft cloth.
ENGLISH
5 www.timberk. com electric humidifier