Timberk TGH 4200 SM1, Инструкция по эксплуатации, Страница: 14 / 20

IM2020
14
8. The appliance is ready for work. During operation of the appliance, watch that the gas cylinder is always
strictly vertical. Use of the cylinder in any other position may result in occurrence of an emergency situation,
breakdown of the appliance, and infliction of a significant damage to you and/or your property.
It is prohibited to move or anyhow cover the heater during operation, as well as after shutdown, if the heater
is still hot. The heater should be placed for operation so that its face plate is directed towards the room
center. At that, distances to walls or other objects on sides and behind the appliance should be at least 1 m.
8. OPERATION OF THE DEVICE
Ventilation
During the operation of the gas heater, the oxygen contained in the air is burned and carbon dioxide (CO
2
) is
released.
It is important to remember that the operation of a gas ceramic heater is permissible only in well-ventilated
areas. This allows to maintain the necessary concentration of oxygen in the air and remove products of
combustion.
In closed, poorly ventilated rooms, during the operation of the heater, a hard-to-breathe atmosphere may be
created and a lack of oxygen may form. If the oxygen concentration drops below 18%, the ODS (oxygen
level monitoring sensor) will work and turn off the heater. In this case, it is necessary to ventilate the room
before turning on the heating mode again.
ATTENTION!
Do not use the gas ceramic heater in rooms with a volume of less than 84 m
3
.
The minimum area of the vent must be at least 105 cm
2
.
The required air exchange is 10 m
3
/ h per 1 kW of heat output of the heater.
Control panel
Fig. 2
1. Gas adjustment knob
Used to supply gas to the burner and select the heating mode:
1st stage (
position),
2nd stage ( position)
3rd step ( position)
2. Piezo ignition button
Used to ignite the burner.
Turning on
1. Gently unscrew the gas cylinder valve.
2. Press and gently turn the gas adjustment knob on the control panel to the (
) position (Fig. 2).
Continue to hold down the gas adjustment knob for 20-30 seconds. Press the piezo ignition button several
times at a time until the gas burner lights up. Each time you press the piezo ignition button, you can hear a