Timberk TFH T20FSN.LZ, Инструкция по эксплуатации

Страница: 6 / 20

www.timberk.com • Electric fan heater
6
Unit operation
1. Before inserting the plug into an electrical outlet, make sure that the
electrical supply in your area matches that on the rating label on the unit.
2. When plugged in, turn on the Main power switch (1) at the rear of the
upper of the heater
3. When in Standby mode, only ON/OFF on the control panel will respond
to your touch. Press «» to access the rest of the control panel.
• Low Power/High Power touch «Mode» once 1000W, touch again
2000W,then off heating function
• Setting the temperature: the temperature in system is 26°C when the
power in on. Press « » or « » to setting the temperatures for the
heating, it is from 15°C to 35°C, the LED display shows the Ambient
Temperature in the room.
• TIMER: Press «TIMER» repeatedly to set a period after which the heater
will turn itself off (between 0 hour – 9.0 hours),each press is 1 hour.
• ON/OFF, turn on or turn off item, item always keep working 30 seconds
of cool air after turn off it, this design can protect item use longer.
Remote controller (RC)
Remote controller must be directed to the signal receiver, located on the
fan heater. The fan heater confirms receipt of the control command by a
sound signal.
1. Button «POWER»
Is used to turn on/off the device in standby mode
2. Button «MODE»
Used to select the heating power or ventilation mode without heating
3. Button « »
Used to set the desired temperature value or timer
4. Button «TIMER»
Used to select the mode of timer set
5. Button « »
Used to set the desired temperature value or timer
Mounting of batteries
The remote controller is power supplied from two AAA batteries (not
included in the scope of delivery), installed in a special compartment whose
cover is located on the back panel of the remote controller. To mount
batteries:
1. Remove the cover of the battery compartment by sliding it along the
direction of the arrow.
2. Mount batteries, observing specified polarity.
3. Place the cover back.
Fig. 3
1
2
3
4
5
IMPORTANT!
External appearance of the remote controller may
be altered by the manufacturer without notice of the
consumer to modify it and improve its external design.
After switching off, the unit will operate in the fan only
mode to cool down heating elements for about 30
seconds. Then the fan heater will be switched off.