Timberk TEC.PF10 LE 1000 IN, Инструкция по эксплуатации

Страница: 8 / 24

www.timberk.com • electric convector heater
8
The unit must be cleaned regularly to remove dust and dirt from external
surfaces, since it affects its operation efficiency and temperature
parameters of room heating. Prior to preventive operations, switch off
the unit and disconnect it from electric mains, let it cool down, then wipe
its surface by a soft and slightly damp duster. It is not recommended to
use detergents for washing, including materials with abrasive elements.
Prevent damaging the unit by sharp objects, since scratches on a painted
surface may cause rusting.
Rear surface of the convector must also be regularly cleaned from dust and
dirt. For this purpose it is necessary to dismount the unit from the bracket,
and after cleaning it is necessary to return it to the initial position.
Preventive cleaning should be performed regularly to maintain technical
condition of the convector and preserve its external appearance for a long
time.
1. On/off button of the device
2. Mode select button power
3. Button lock function «Child lock»
4. Button set timer
5. Function buttons
Rules of the use of the remote control.
1. To work correctly when using the remote control, always point the IR
emitter signal directly at signal receiver on the front panel convector.
2. Avoid direct sunlight on the remote control
3. Do not drop the remote control and do not expose it to moisture
4. Promptly replace the batteries in the remote control
5. If not supposed to use the remote control for a long time, then be sure
to remove the batteries to prevent oxidation of contact elements remote
control.
Battery installation (Fig.8)
1. Open the cover of the battery, pushing the locking lever to the right and
pull the compartment down. Remove the tray for a battery.
2. Insert the battery type CR2025
3. Set the tray for the batteries in the remote control
IMPORTANT!
Management of the convector is possible using the
remote control supplied with the device. Remote
control allows to control all the functions of the
convector: enable or disable the device, select the
power mode of the heating temperature adjustment,
timer setting to disable, enable or disable the «Child
Lock».
5 seconds with no operation.
6. Timer function of the convector turning on
After you press « » under standby condition, then «0» flicker(means 0
hour)+« » (means hour)light, then you press « » or « » button, heater
will turn on after 1 or 24 hours
7. Interlock function «Child lock»
7.1. To lock the control convector simultaneously press buttons « » and
« »
7.2. On the display indicator « »
7.3. To unlock the control panel push buttons « » and « ».
Remote control of the convector series TEC.PF8 LE…IN,
TEC.PF9 LE…IN, TEC.PF10 LE...IN
Fig. 7
8. MAINTENANCE