Timberk TCH A9 1000, Инструкция по эксплуатации

Страница: 7 / 28

www.timberk.com • electric ceiling heater
7
IMPORTANT!
The power outlet should be rated at least 10A for models with a
maximum capacity of up to 1800 W and at least 16A for models with
a maximum capacity of more than 1800 W.
IMPORTANT!
Slight crackles may be heard during operation at the moment of
heating or cooling, which disappear, when the heater reaches the
working mode.
IMPORTANT!
After installation of the heater and before switching for the first time,
it is necessary to wipe the radiating board with alcohol. After that, it
is PROHIBITED to touch the radiating board.
CONNECTING TO THE MAINS
1. The heater is designed for connection to the single-phase 220 V~, 50 Hz
electric mains equipped with a grounding loop.
2. Before connection, make sure that specifications of the electric mains
at the connection point meet the parameters indicated on the appliance
nameplate.
3. The electric mains should be equipped with an automatic circuit breaker
with rated current not less than 16A
4. For connection of the heater to the electric mains, it is necessary to do
the following:
• remove the cover from the heater, cut a hole in the rubber seal, insert the
electric cable to the heater, tightly fix the bare ends of the electric cable in
the junction block of the heater with screws in strict correspondence with
marking on the block, reinstall the cover.
1. The heater is designed for connection to the single-phase 220 V~, 50 Hz
electric mains equipped with a grounding loop.
2. Before connection, make sure that specifications of the electric mains
at the connection point meet the parameters indicated on the appliance
nameplate.
3. The electric mains should be equipped with an automatic circuit breaker
with rated current not less than 16A
4. For connection of the heater to the electric mains, it is necessary to do
the following:
• remove the cover from the heater, cut a hole in the rubber seal, insert the
electric cable to the heater, tightly fix the bare ends of the electric cable in
the junction block of the heater with screws in strict correspondence with
marking on the block, reinstall the cover.
NOTE:
The instruction manual for remote control block is not included in
the scope of delivery. Should be bought separately.
NOTE:
Discoloration of paint on the heater body wall directed to the ceiling
during operation is not a defect. Changing of color for heating plates
is not defect.
7. OPERATION