Timberk SWH SE1 10 VO, Инструкция по эксплуатации

Страница: 6 / 36

www.timberk.com • electrical storage water heater
6
6. DELIVERY SET
7. WATER HEATER INSTALLATION
1. Electric storage water heater – 1 pc.
2. Pressure safety valve – 1 pc.
3. Mounting strip for hanging/mounting of water heater – 1 pcs.
4. Instruction manual – 1 pc.
5. Guarantee card – 1 pc.
6. Packing – 1 pc.
Location
1. The water heater of SWH SE1 VO series can be installed over a
washbasin, a kitchen sink or in any other place where it will not hinder you.
Please, note, that pipes must be placed on the bottom part of water heater.
2. The water heater of
SWH SE1 VU series can be installed under a
washbasin, a kitchen sink or in any other place where it will not hinder you.
Please, note, that pipes must be placed on the top part of water heater.
3. Electric water heater should be mounted on a firm wall.
4. The wall where the electric water heater is to be mounted must withstand
at least the double weight of the water heater fully filled with water. There
must be no cracks and other damages on the wall. Otherwise, it is necessary
to take measures to strengthen the mounting or install the water heater on
a special support.
5. If a bathroom is too small the water heater can be installed in any other
place unexposed to direct sunlight and beyond the reach of moisture.
However, to reduce heat losses in pipelines the location where the water
heater is to be installed must be as close to the place of hot water use as
possible.
Water heater mounting
1. After you have chosen a proper place to install the water heater
determine points for holes for fixing of mounting strip, putting the strip to a
wall. Drill holes of corresponding depth in the wall using a drill dimensionally
fit for anchor bolts delivered together with the water heater. Next, fix the
mounting strip on a wall with help of screws. After that you should mount
water heater on a mounting strip (fig. 7).
Connection to the water main
1. The water heater must be connected to the water main with minimum
pressure of 0.1 MPa and maximum pressure of 0.7 MPa.
NOTE:
To install the water heater, please, use accessories
provided by the manufacturer. Electric water heater
must not be mounted onto the wall before you make
sure that the mounting strip is installed firmly and
securely. Otherwise, the electric water heater may fall
down from the wall that may cause its damage and
even more serious accidents involving harm to health
and personal injuries.
NOTE:
In the places accessible for water the AC electrical
main socket must be installed on a height of at least
1.8 m from the ground.
2. Fasten an AC main socket to the wall. Requirements to the socket are
as follows: ~220V / 10А, single-phase, three wires. It is recommended to
place the socket from the right side higher of the water heater.
Fig. 7