Timberk DH TIM 10 E5, Инструкция по эксплуатации

Страница: 6 / 28

www.timberk.com • Electric drier for changing of air humidity
6
7. MAINTENANCE
There are two ways to remove collected water.
1. Use the bucket
When the bucket is full, the unit will automatically stop running, and the
Full indicator light will flash.
Slowly pull out the bucket. Grip the left and right handles securely, and
carefully pull out straight so water does not spill. Do not put the bucket
on the floor because the bottom of the bucket is uneven. Otherwise the
bucket will fall and cause the water to spill.
Throw away the water and replace the bucket. The bucket must be in
place and securely seated for the dehumidifier to operate.
The machine will re-start when the bucket is restored in its correct
position.
2. Continuous draining
Water can be automatically emptied into a floor drain by attaching the unit
with a water hose (ID 13.5mm) (not included).
• Remove the rubber plug from the back of the unit and store it in a safe
location.
• Insert the water hose into the unit from the drain outlet in the back of
the unit as shown in Fig.5. Make sure the connection of the water hose
and the drain hose outlet of the unit is tight and do not let the water leak.
• Then lead the water hose to the floor drain or a suitable drainage facility.
The drainage facility should be lower than the drain outlet of the unit.
• Be sure to run the water hose sloping downward and let the water to
flow out smoothly.Do not install the water hose as shown Fig.6.
Other features
Bucket Full Light
Glows when the bucket is ready to be emptied, or when the bucket is
removed or not replaced in the proper position.
Auto Shut
Off The water level control switch shuts off the dehumidifier when the
bucket is full, or when the bucket is removed or not replaced in the proper
position. When the setting humidity is reached, the unit will be shut off
automatically.
Wait 3 minutes before resuming operation
After the unit has stopped, it can not be restart opertation in the first 3
minutes. This is to protect the unit. Operation will automatically start after
3 minutes.
Auto Defrost
When frost builds up on the evaporator coils, the compressor will cycle off
and the fan will continue to run until the frost disappears.
Auto-Restart(on some models)
If the unit breaks off unexpectedly due to the power cut, it will restart with
the previous function setting automatically when the power resumes.
NOTE:
When you remove the bucket, do not touch any parts
inside of the unit. Doing so may damage the product. Be
sure to push the bucket gently all the way into the unit.
Banging the bucket against anything or failing to push it
in securely may cause the unit not to operate.
NOTE:
When the continuous drain feature is not being
used,remove the drain hose from the outlet and attach
the rubber plug back to the drain outlet.
Fig. 4.
Pull out the bucket a little. Hold both sides of the bucket
with even strength, and pull it
out from the unit.
Pour the water out.