Timberk AC TIM 05H P4, Инструкция по эксплуатации

Страница: 10 / 26

Trouble Cause Troubleshooting method
The air conditioner is not switched on
when Power b utton is pressed The tank fill-up indicator is flashi ng, the
condensate collecti on tray is filled up Drain water from the tray
Actual room temperature is higher than the
set one (in heati ng mode) Set the temperature correctly
The air conditioner switches off in
heating mode Automatic overheating protection is tripped .
The unit is swi tch ed off in case the outlet air
temperature goes higher than 70°C Wait until the air conditioner cools
down and switch it on again
Loud noise or strong vib ration The air conditioner is installed on an inclined
or un smooth surface Install the air conditioner on a
smooth horizontal surface
A noise, resembling a gurgle of water Noise emerges due to refrigerant flow i n
pipes It is normal
9
ENGLISH
10. TROUBLESHOOTING
Trouble Cause Troubleshooting method
E1 Short circuit on a temperature sensor or a
processor board Contact an authorized service
center
E2 Short circuit between a copper pipe of the
temperature sensor and the processor board
wiring Contact an authorized service
center
E3 It indicates the tank is filled up with water or
the plug is connected incorrectly Remove the rubber plug, located at
the bottom of the unit, and drain
water. Then check if the plug is
connected correctly.
Such marking indicates that disposal of this product along with other domestic waste is forbidden in the EU. To prevent environmental or health damage as a result of
uncontrolled waste disposal, please hand this product for recycling to enable rational use of material resources. To return the device you used, please use the collection
and return system or contact the point of sale, where the device was purchased. They can take it for an environmentally safe disposal.
Error codes for LED-display model ( A C TIM 09HE P 4 )
www.timberk.com electric floor standing air onditioner ortable type (single case)