-3-
Burn time and light power
17.
The burn time and the light power of the torch depends on
- the used LED module
- the used type of battery or rechargeable battery.
TIPP : Various LED modules can be purchased on the internet market, starts from
about 6 Euro. Search for "P60 drop in" modules !
Operation and Handling / Changing the LED moduls
18.
Mount the rechargable battery 18650 oder non rechargeable batteries (optional with long
battery tube) with the plus pole upwards in the direction of the head.
19.
Minus pole shows at the bottom of battery tube.
20.
To turn your torch on and off, rotate the torch head. A half rotation is sufficient to engage
the contacts. Further rotation when switching off is not a problem as the system is protected
with 3 O-rings, however it should be stopped when the first O-ring is visible.
21.
Change the LED module as following:
- dismonted blue protection ring (made from rubber)
- screw off the battery tube (1)
- dismounted the front ring (2) on the glass, remove the non fixed O-ring (is located
between front ring and glass)
- remove glass (4)
Important : The glass is easier to remove if you press in the light head (3)
LIGHTLY
against the LED module / keep light head down, prefer a soft underlay, because glass
and LED module can fall out!
- Remove existing LED module (is not fixed in the light head)
- Mount the new LED – module, slightly push down the LED module until the inner
O-ring (5) is good visible - do not remove inner O-ring (5) !
- Grease the visible inner O-ring (5)
- Insert the glass (4) correctly (observe the direction) - large groove (6) above,
small groove down (press the glass down in the direction of the light head).
- Grease the non fixed O-ring and apply it loose in the large groove (6) oft he glass.
- Screw straight the front ring (2) – do not jam !
- Check, that the O- ring is not squeezed.
- Mount the blue protection ring (rubber ring).
User manual Maxi uni
Notes for using of charger
22.
The hints of the operating instructions of the manufacturer are to be observed.
23.
The charger has several LED lamps that indicate the progress of the battery charge.
24.
The charger can connected to the battery verytime. You do not have to discharge
the battery !
IMPORTANT: Use chargers only indoor or in dry rooms. The voltage values and
settings must be respected.
