tilgin HG2280 series, Быстрое руководство

Страница: 8 / 20

6
4.1 Connecting to the Internet (WAN)
The operator might offer Internet access using either ADSL2+, VDSL2 or Ethernet access.
Please refer to the documentation provided by the operator for information on how to connect
the device to Internet (WAN).
For Internet access using ADSL2+ and VDSL2 technology the internet network cable should
be connected to outlet 1 (on the gateway) and to the ADSL2+/VDSL2 outlet offered by the
operator, normally the phone socket on the wall. In many cases a splitter must be connected
between the gateway and the phone socket on the wall, please refer to instructions provided
by the operator for proper connection.
For internet access using Ethernet technology the internet network cable should be
connected to outlet #3 (on the gateway) and to the Ethernet access port offered by the
operator.
Note that either outlet 1 or outlet 3 should be used, not both.
If your gateway first has connected to Internet using ADSL2+ or VDSL2 technology and you
later switch to connecting to Internet using Ethernet, or vice versa, the following steps are
needed.
- Connect and use the correct WAN cable as described above
- Remove the old WAN cable on the gateway
- Restart the gateway by turning off and on the power of the gateway using the ON/OFF-
Button (#8).
4.2 Connect the power cord to the AC/DC adapter
1. Connect the AC/DC adapter power cord to the power connector (#7) on the backside of
the unit.
2. Plug the power cord into a power outlet.
3. Push the ON/OFF-Button (#8) on the backside to ON
4. Check that the power LED on the front side is lit (red).
4.3 Automatic Provisioning
When the home gateway is properly connected, an automatic configuration will begin.
The home gateway is pre-loaded with software but it will always download newer software
and settings from your operator.
Just wait until the power LED turns stable orange, which normally takes a few minutes, but
may take up to 30 minutes. If the LED still has not turned stable orange after 30 minutes,
then reboot (push power ON/OFF-button). If problem persists, contact your operator.
For more information about the LED status, see LEDs Front .