TECHNISONIC INDUSTRIES LIMITED
www.til.ca
TBS-150, 250, 350 Installation & Operating Instructions
TiL 92RE122 Rev L
2-1
SECTION 2 – OPERATING INSTRUCTIONS
2.1 GENERAL
This section provides the information required for custom configuration of the base station,
and storage. Custom system configuration includes customizing remote control set up, and
removal and replacement of Power Amplifier Module, Transceiver, and Power Supply.
Refer to Section 3 for Channel/Frequency configuration.
Remote set up instructions for Mark II series Line Interface boards P/N's 923051-1 and
943180-1 are provided in paragraph 2.3 of this section.
2.2 DISASSEMBLY/ASSEMBLY
(Refer to Figure 2.1)
2.2.1 Remove/Replace Microphone
REMOVAL
(1)
Disconnect microphone (item 7) from front panel of transceiver (item 8). Slide
microphone clear of bracket (item 6).
(2)
Remove and Retain two screws (item 5) securing microphone bracket (item 6) to
cover (item 2).
REPLACEMENT
(1)
Secure microphone bracket (item 6) to left or right side of cover (item 3) as required
with two screws and two washers (item 5).
(2)
Connect microphone (item 7) to front panel connector on transceiver (item 8). Slide
microphone onto bracket (item 6).
2.2.2 Remove/Replace Cover Assembly
NOTE
It is necessary to first remove Microphone Bracket
before removing Cover.
Remove screws securing Heat Sink to cover last, after
removing all other top and bottom screws.
