1792 VHF Radio
User's Manual
7
2.1.3 Replace the Bottom Enclosure Cover
1.
Position the bottom cover on the chassis.
2.
Position one screw in each corner of the bottom cover mounting holes.
3.
Secure the three screws for the “inside” of the enclosure cover.
4.
Secure the remaining screws in the holes around the enclosure perimeter.
2.2
MOUNTING BRACKET
The CDP rack’s bottom shelf (Figure 4) is fixed in place. Components are accessible through the
rack’s front or side doors. The VHF radio is secured to the bottom side of the sliding top shelf using
the mounting bracket, with the control knobs facing to the right when the VHF radio is viewed from
the front end of the CDP rack.
Figure 4. CDP Bottom-Shelf Components
The mounting bracket and the VHF radio are installed at the factory. Should the need arise to remove
the radio, undo the wing screws on either side of the radio. Because of the tight space inside the CDP
rack, it is recommended that any connecting cables remain in place until the VHF radio is removed
from the mounting bracket. Any cables that have been removed should be reattached before mounting
the VHF radio back in the mounting bracket.
There is no need to remove the mounting bracket itself.
