www.tiiwee.com
Please follow the below steps carefully.
Receiver
1. Remove the battery compartment cover by removing the screw
2. Insert the batteries into the receiver ensuring the correct polarity
3
. Press and hold the volume button until the receiver emits two short beeps
to indicate
that it is ready for pairing
Sensor
4. Remove the battery compartment cover by removing the screws
5. Insert the batteries into the sensor ensuring the correct polarity
6. The receiver will emit
two short beeps indicating that the sensor is now paired
with
the receiver
7.
If the sensor detects motion for the first time the receiver will emit
another two short
control beeps
indicating it is functional
The receiver and the sensor are now fully functional. Whenever motion is detected by the
sensor you will hear the alarm sound and the receiver light will also flash.
Replacing the batteries
•
Remove the battery compartment cover by removing the
screw(s).
•
Insert the batteries ensuring the battery polarity corresponds
with the markings on
the battery compartment.
•
Close the battery compartment cover.
Note:
The LED’s on the receiver and
the sensor will light continuously when the batteries run
low and need to be replaced.
DC 6V Socket
The receiver is fitted with a DC 6V socket for use with a 6V - 200mA mains adapter (not
supplied). This can be used to power the receiver instead of batteries.
Note:
The
batteries and a mains adapter can’t be used at the same time.
