Tigmig KL-MIG 100E, Руководство пользователя

Страница: 7 / 12

molybdenum disulfide.
5. Carefully check bolts and screws for tightening. If any play is found, please fasten them
thoroughly.
6. In case that any fault occurs to the machine or it needs repairing, please tell the machine model
and product number to the supplier as soon as possible.
• Cautions
1. Please confirm rated specifications on the nameplate to avoid the unreasonable
use before any operation.
2. Avoiding the overload operation.
(1) The serious overloads can burn the machine. Even if it isn’t broken, its life
will be shortened.
(2) The overload will cause the noise and make the current-adjusting handwheel
can’t turn freely.
3. The connection between the welding terminal and cable should be firm. Be aware
that poor connection will make the part heated, or terminal and cable burned.
4. If the output cable is too long, it will make current circulation blocked and
increase the power consumption. If too old cable makes the surface insulation
damaged and unstable arc generate, please renew the cable.
5. Welding current is influenced by thickness of welded plate, size of welding rod,
welding attitude, etc. The relations between diameter of welding rod and current
value are shown in the table on right side. (Note: suitable for carbon steel and low
alloy steel)
• Cautions of Flux wire
Diameter of Flux wire Welding Current (A)
0.6 60-80
0.8 60-100
0.9 60-110
6. Be sure to turn off the power supply after finishing the job.
7. Do not use the machine so long time under the sun in summer and try to put it
under the shield. In addition, put it away from the rain or at places with heavy
humidity and much iron power and dust.
8. During the operation, the housing temperature is very high (50 to 70
H
), but the
winding should be used according to the load cycle rate due to H level insulations.
9. Cautions for suitable frequency
(1) Do not use any 60HZ welding machine in the 50HZ area.
(2) The 50HZ welding machine can be used in the 60HZ area, but output current,
input capacity and power factors will change.
10. Try to keep voltage stable, the welding machine had better not run under the
fluctuating voltage.
a. When the power voltage is below the rated input voltage of the machine:
(1) The welding current is quite low.
(2) Broken arc or unstable arc generates.
b. When exceeding the rated input voltage:
(1) The welding current is quite strong.
(2) Noises generate or the current-adjusting handwheel can’t turn freely.
(3) The shortened life is resulted in.
11. To prevent the operator from accidental injuries, please remember to wear the