Use and Maintenance Manual - Series V8 E V10 E
Page 30
5.1.3.
Other functions of the platform control panel.
5.1.3.1.
Manual horn
It warns that the machine is moving; it is manually operated by means of the press-button
F
.
5.1.3.2.
Emergency stop button
By pressing the red emergency STOP button
E
all control functions of the machine are stopped. Normal functions are enabled by
rotating the button of 1/4 turn clockwise.
5.1.3.3.
Warning lights
Fig. 8
5.1.3.3.1.
Enabled control panel green warning light (ZA)
Lit up flashing when the machine is turned on. If the platform control panel has been selected and this light flashes the controls are
not enabled because the dead-man pedal is not pressed or it was pressed for more than 10 seconds and no operation was performed
or dead-man button was not pressed or more than 2 seconds went by since its release and no operation was performed.
On steady with machine on and dead-man pedal pressed for less than 10 seconds or dead-man button pressed and released for
less than 2 seconds. With platform control panel all controls are enabled (unless other types of warning show up
–
see next
paragraphs).
5.1.3.3.2.
Red warning light: flat battery (ZB)
Flashing when battery is charged at 20% only. In this condition, platform lifting is disabled. Batteries should be immediately recharged.
5.1.3.3.3.
Danger red warning light (ZC)
It flashes quickly for 4 seconds together with the audible alarm at the machine start-up in case of fault during safety test on controls
(pedal, joystick control, switches, etc).
It is lit up steady together with the audible alarm (just in case of lifted platform) when the chassis inclination exceeds the allowed
value. The lifting of the telescopic column is inhibited (the JIB lifting stays active). If platform is lifted, drive is also disabled. It is
necessary to lower the booms completely and then place the machine onto a flat surface.
It is lit up without the audible alarm with booms raised and one or both of the pot-hole guards not perfectly lowered. All platform
movement controls are possible but drive with raised platform is automatically disabled.
Содержание Airo V Series
