TIGIEFFE Airo V Series, Руководство по эксплуатации и обслуживанию

Страница: 25 / 103

Use and Maintenance Manual - Series V8 E V10 E Page 25
4. INSTALLATION AND PRELIMINARY CHECKS
The machine is supplied completely assembled, therefore it can perform all functions in full safety as provided for by the manufacturer.
No preliminary operation is required. To unload the machine, follow the instructions in chapter “Handling and carrying”.
Place the mac hine onto a firm ground and with a gradeability lower than the max. allowed (see technical features “ Stability limits ”).
4.1. Becoming acquainted with the machine
Anyone wishing to use a machine with weight, height, width and length characteristics or which generally differs significantly from the
training received must be updated in order to cover the differences.
The employer shall be responsible for ensuring all the operators who use work equipment are adequately trained and in order with
applicable health and safety legislation.
4.2. Preliminary operation checks
Before using the machine read the instructions given in this manual and the concise instructions indicated on the platform plate.
Check the perfect integrity of the machine (by sight check) and read the plates showing machine operating limits.
Before using the machine, the operator must always check visually that:
▪
The battery is completely charged.
▪
The oil level lies between the min. and max. value (with lowered platform).
▪
The ground is sufficiently horizontal and solid.
▪
The machine carries out all operations in safety.
▪
The wheels and drive motors are properly fixed.
▪ The wheels are in good condition.
▪ Make sure the rails are fastened to the platform and the gate/s are in automatic reclosing mode.
▪ The structure does not show clear faults (visually check welding of lifting structure).
▪ The instructions plates are perfectly readable.
▪ the controls are perfectly efficient both at operator position and at emergency ground control panel, including dead-man system.
▪
The protection door of the emergency key of the system FACTORY OVERRIDE is in on position fixed with screw and blocked
with lead seal
▪
The anchoring points for the harness are in perfect state of conservation.
Do not use the machine for purposes different from those it was intended for.