For assistance with installation, call us at 507.246.3545
2 - Install Seat Bottom Cover
Driver’s Side
q
2.1 - Place seat cover over seat bottom.
q
2.2 - Ensure seat belt latch goes through hole in cover.
q
2.3 - Run outside string between seat back and bottom, as shown in picture. Once ran between back and bottom,
string should be tucked between seat bottom and plastic trim. Make sure string runs through outside car seat
anchor. Inside string goes straight down, under seat bottom as shown in picture.
q
2.4 - Tip seat bottom up.
q
2.5 - Pull strings tight.
q
2.6 - Tie a loop in one string. Run the other string through the loop, pull tight, and tie string back on itself. It is
important to pull tight as this is what keeps your cover from shifting.
q
2.7 - Push top flap between seat back and seat bottom, ensuring that car seat anchors go through holes in cover.
q
2.8 - Run front flaps under front of seat. Pull flaps tight and fasten to Velcro on top flaps.
Repeat for Passenger’s Side
