TigerStop TigerRack, Руководство по установке

Страница: 12 / 36

12
The Standard Interconnect Kit integrates TigerRack with your tool. Once installed, TigerRack will know
when the tool is cycling and when the cycle is completed. This has a number of benefits;
Safety
When installed, TigerRack will be able to prevent the tool from cycling while it is in motion. TigerRack is
also prevented from moving when the tool is in mid-cycle.
Automation
An additional benefit is partial automation of the tool, when using TigerStop’s Dynamic Optimization.
Once installed, TigerRack will read when the saw cycle is complete and will then move to the next part
size automatically, instead of waiting for the operator to signal for the next move. This dramatically
speeds up part throughput and lowers material waste when performing Backboard Defecting &
Optimizing using TigerStop’s Dynamic Optimization upgrade.
WARNING!
Using a TigerStop Standard Interconnect Kit does NOT relieve you of the responsibility
for making sure your saw or other tool has all the necessary safety equipment in place.
Install Standard Interconnect Kit
The TigerStop Standard Interconnect Kit has two components that integrate into your tool;
Mechanical Limit Switch
Mounted on the tool, this switch tells TigerRack if the tool is cycling.
Pneumatic Solenoid Valve
Plumbed into the air line that activates your tool, this solenoid valve will cut off air to the tool when
TigerRack is moving.
Mount the limit switch anywhere on the tool so that when the
tool is at its resting position, the switch is pressed.
Note: When the tool is cycled, the switch should become unpressed. When
the tool returns from the cycle, the switch should return to the pressed
position.