TigerStop TigerRack, Руководство по установке

Страница: 10 / 36

10
3. Set the loose rack in place and tighten down to a torque specification of 380 in-lbs.
Adjust the Pinion
The pinion gear rides along the rack and moves the carriage. The pinion must be checked to ensure it
is properly adjusted before putting TigerRack into service.
To check the pinion tension...
Note: Ensure TigerRack is powered down before adjusting the pinion gear.
1. Remove the screws holding the motor box cover in place.
2. Swing open the motor box cover.
3. Lower the pinion gear by hand.
4. Insert a piece of paper between the pinion and the rack.
5. Slowly release the pinion and allow it to push the paper into the rack.
6. Remove the paper. The paper should be embossed by the rack, but not ripped or torn.
7. If the paper is not embossed, or if its torn you will need to adjust the pinion.
To adjust the pinion...
Note: Ensure TigerRack is powered down before adjusting the pinion gear.
1. Remove the screws holding the motor box cover in place.
2. Swing open the motor box cover.
3. Tighten the pinion spring by tightening the spring bolt.
4. Check the pinion tension and modify tension as necessary.
Spring
Bolt