Tiger JD 5065M, Руководство по эксплуатации

Страница: 48 / 202

ASSEMBLY
Assembly Section 2-22
MOWER MOUNTING
Check that all grease zerks have been installed in the draft beams pivot arm, left
linkage arm, right linkage arm, and cylinder mounting ears.
Using a clevis pin and roll pins, connect the pivot arm to clevis on draft beam.
NOTE: Make sure the longer distance between the cutout and the end of the pivot
arm is closest to the draft beam pivot ears on the center tube as shown in the diagram
below. Also make sure the cutout on the pivot arm faces into tube of draft beam.
(ASM-C-0077)
Slide other end of pivot arm with short distance between the cut-out and the end
of the pivot arm, into the cylinder clevis. Next, line up the holes of the left and right lift
linkage arms outside of the cylinder clevis holes. Connect with linkage pin, shims (as
required), boss, cap-screw, lock-washer and hex nut as shown.
To connect the bonnet to the draft beam, slide the extension arms of the draft
beam between the mounting ears on the inner end of the bonnet. Line up the holes
and secure with swivel pin, cap-screw, lock-washer, and hex nut (both sides). See
parts book illustration.
Next, slide the left and right linkage arms up to the slotted ear on the side of the
deck. Secure with linkage pin, shims, boss, cap-screw, lock-washer and hex nut. See
illustration in Parts Section.
LIFT CONTROL FEEDLINES
Hose lengths will vary between tractor applications such as cab and non-cab units.
See the Parts Section that pertains to your tractor for hose applications.
Install a hose from the bottom or inner valve port (behind cab for cab units, on stand
for non-cab units) to the restrictor on the inboard cylinder gland.
Install a hose from the upper or outer valve port to the restrictor on the outboard
cylinder butt.
See Parts Section for part numbers and hose routing illustrations.
(ASM-C-0093)