Tiger BENGAL BRUTE, Монтаж и эксплуатация

Страница: 67 / 318

ASSEMBLY
Assembly Section 2-35
HOSE COVERING
Secure hoses together with zip ties wherever loose. Wrap the hoses between the swivel and
main boom with the hose cover provided. Wrap the hoses between the main boom and
secondary boom with the hose cover provided. Where hoses may contact the frame or other
edges, wrap with split hose and secure with hose clamps or zip ties.
On non cab units, the pressure and return hoses from the control valve will also need to be
routed inside the protective clear hose wrap. Cover the valve, valve fittings with the yellow hose
cover and secure with black string provided.
(ASM-C-0058)
ACCUMULATOR INSTALLATION
Install the accumulator bracket on tab with holes provided on the right main frame or lift valve
mount, if applicable, with the capscrews and lockwashers as shown in the Parts Section. Install
the accumulator in the bracket and secure with the hardware shown. Install fittings and hoses to
the cylinder and control valve as shown in the Parts Section.
Use teflon tape on all pipe
fittings (except O-rings).
(ASM-C-0012)
SOLENOID BRAKE VALVE
Install a solenoid valve on the mounting bracket with the supplied hardware as shown in the
Parts Section in this manual. While installing the fittings to the brake valve, the electical coil on
the spool may have to be removed to make room. When reinstalling the coil, it is important to
use no more than 5 ft. lbs. (or 60in. lbs.) torque. WARNING: OVER TORQUE TO THE COIL
WILL RESULT IN HYDRAULIC FAILURE OF SPOOL.
(ASM-C-0025)
TEMPERATURE GAUGE MOUNTING
(OPTIONAL)
Mount the temperature gauge where it is clearly visible to the operator. Attach the green (-)
wire from the negative post on the gauge to a grounded bolt on the tractor frame. Remove paint
if needed to make a good ground. Remove the pipe plug from the side of the hydraulic reservoir
and install the temperature sensor using thread sealing tape. Run the white wire from the (s)
sensor post of the gauge to the temperature sensor on the hydraulic reservoir tank.
(ASM-C-0051)
WHEEL WEIGHT MOUNTING
For all tractors using a boom mower, a wheel weight will be required for the rear left side
wheel. It will be necessary to mount the weight in the wheel using the long capscrews,
lockwashers, flatwashers, spacers (if applicable), and hex nuts per the diagram in the parts
section.
Installation is most easily done with a fork lift, inserting a fork in the center slot of the wheel
weight. The head of the capscrews is to be toward the OUTSIDE of the weight, with flatwashers
on both the inside and outside of the assembly.
The left rear tire may also be filled with a mixture of water and calcium chloride at about five
pounds per gallon. Tire air pressure should be maintained according to the Maintenance
Section.
(ASM-C-0055)