Operating Instructions
Race Installation
CAUTION:
Always follow Manufacturers recommendations
when servicing bearing races.
1
Thoroughly clean the hub and remove any burrs from the
race seat.
2
Lay the wheel/tire assembly on its side and position the
new race in the hub with the corresponding install adapter
on to the race.
(Figure A)
3
Using a hammer tap the install plate evenly around the outer
perimeter to get the race started parallel to the seat.
4
Remove the install plate and lift the wheel/tire assembly
upright.
5
Insert the threaded rod into the install adapter with a
supplied washer and nut against the flat side of the install
plate.
6
Insert the rod and install adapter through the hub
with the tapered side of the adapter to the tapered
side of the race.
(Figure B)
7
Place the hydraulic cylinder and hat over the threaded rod
and install supplied washer and nut hand tight.
A
B
1.800.661.4661
View demonstration videos and a
complete product list at
tigertool.com
Technical Support
Have What It Takes
10910
Hydraulic Bearing Race Starter
Kit w/o Cylinder
