Operating Instructions
1
Clean bearing cup bores of all rust and debris.
2
Select & install the correct anvil for the driveline being
worked on:
A
For the Spicer driveshaft – use the “SPL 350” anvil
B
For the Meritor driveshaft – use the “RPL 35” anvil
3
Press one bearing cup into the yoke by hand, then place
the tool over top of the yoke/protruding bearing cup.
(Figure 1)
4
Using a wrench or ratchet, turn the forcing screw and
press the bearing cup in to the yoke until the bottom of
the cup is flush with the underside of the yoke.
(Figure 2)
5
Rotate the driveshaft 180 degrees and place the U-joint
cross in to the half-installed bearing cup.
6
Repeat steps 3 and 4 on the opposing yoke, making
sure the needle bearings stay in place and the u-joint
cross rotates freely inside the cups.
7
Rotate the driveshaft 180 degrees and press the half-
installed bearing cup down to the installed depth.
(Figure 3)
8
Install new retaining rings. (Figure 4)
Here at Tiger Tool, your satisfaction is our number one
priority. Should you have any questions about this or any
of our products, please call us at 1.800.661.4661.
2
1
3
4
1.800.661.4661
View demonstration videos and a
complete product list at
tigertool.com
Technical Support
Have What It Takes
Severe Heavy Duty
Bearing Cup Installer
10218
