Evidence Locker Installation Instructions
-
Continued
STEP 7
If either the front or rear of the locker will be
proud of the wall, adjust the location of the
recessed trim so that it will be flush with the wall
and present a finished appearance. Secure the
trim with provided sheet metal screws.
STEP 8
Install the top trim angle by drilling 1/8” holes
in the horizontal trim angle and securing it with
the included 3/4” socket head cap screws.
STEP 9
If the run of lockers is longer than 72”, repeat
STEP 7 using the included adder trim kit.
STEP 10
If applicable, field cut the trim to length as
needed using tin snips.
STEP 11
Slide the lockers into the wall opening until the
trim is flush against the wall. At this point, the
recessed trim can be installed on the rear side
of the locker.
STEP 12
Check lockers for plumb and level. If required,
level lockers following the instructions on page 9.
STEP 13
Once the lockers are plumb and level, field drill
two 3/16” holes through the frame. See DETAIL
B. Anchor the lockers to wall or, if the situation
provides, to a wall stud (hardware not included).
7
TOP/BOTTOM TRIM ANGLE
STEP 14
If desired, drill holes through the bottom shelf
for anchoring to the floor (hardware not
included).
STEP 15
Test all doors for correct operation. If there are
any issues with the keyless lift latch, see pages
10-11
for troubleshooting instructions.
