Tiffin Motorhomes 2015 Allegro, Руководство пользователя

Страница: 100 / 152

WINDOWS, AWNINGS, VENTS & DOORS
93
B. Verify that the valance is in the correct orientation (see awning instructions found in Own-
er’s Information Package). Tap the rocker switch in the “Retract” direction to adjust the valance
orientation if necessary. Allowing the valance to remain in the hyper-extended orientation may
create a propensity to pool water, especially in larger (17’-21’) awnings.
To close the awning:
NOTE: Pinch Hazard. When closing awning, bottom arm will fold down and against back
channel. This area must be kept clear of people and objects. Failure to heed this warning
could cause severe personal injury and/or property damage.
1. Locate the Remote Switch near the entry door.
A. Press and hold the “Retract” button to automatically close awning. If the button is released the
awning will stop. Maintain button depressed until awning is fully retracted, then release.
IMPORTANT: As an extra safety precaution, visually verify that the awning is fully closed.
In case of awning power failure or to manually close awning:
IMPORTANT: This procedure will require two people. When this procedure has been per-
formed, the awning must be serviced by a Dometic service center or a qualified service tech-
nician before using again.
There are two methods of rolling up the awning if it appears there is no power to the awning
motor. The following method should be performed first:
1. When the power awning hardware is in the open position and the 12 VDC power has been
lost the awning can be closed by supplying auxiliary power to the hardware. Connect the awning
motor to an external 12 VDC power source via user-supplied wire (16 gauge minimum). A good
external 12 VDC power source would be an automobile battery.
2. Locate and unplug the motor and hardware cable connection located in the upper part of the
right-hand arm.
3. Connect the user-supplied wire leads to the terminals in the connector from the motor. Elec-
trical tape may be required to keep the wire leads in place. (Do not connect to the one in the
hardware).
4. Connect the other end to a 12 VDC battery source. The red wire goes to + and the black to
-. If there is not a problem with the awning motor, this will retract the awning. To avoid motor
damage disconnect battery source immediately after awning is fully retracted.
5. The awning can be extended by reversing the polarity. Place the red wire on the – and the black
wire on the +. Disconnect battery source after awning is fully extended.
If the awning will not retract after performing the steps listed above, perform the following steps.
1. Slide the pull strap (provided) into the utility slot of the FRTA (see awning instructions found
in Owner’s Information Package, page 4 Figure 6).