HOW TO FILL WITH WATER
Make sure the iron is turned off and the power cord is unplugged from the electrical outlet.
1.
Set the ‘Variable’ steam knob to the ‘0’ position before filling the iron with water.
2.
Open the ‘Water Fill’ opening and fill the tank up to the ‘MAX’ line on the tank.
3. The water level can be observed through the transparent part of the tank. When iron is placed
vertically, if the water level becomes low
– refill the tank by following procedure described in steps 1
to 3 above.
4. Pour out the remaining water after use.
HOW TO USE THE DRY IRON
1. Position the iron vertically.
2. Insert the plug in the power outlet and turn the power on.
3.
Set “Steam regulating knob” to “MIN” position.
4. Preheat the iron until the indicator light goes out.
Now dry ironing can being.
HOW TO USE THE SPRAY
Before using the spray feature, please make sure the garment
’s fabric label for ironing instructions because
some fabrics may be spotted or stained with moisture.
The spray feature is particularly helpful for removing stubborn wrinkles and where extra dampening is
needed. The spray may be used with steam or dry ironing. Simply pump the “Spray mist knob” where the
spray is desired.
HOW TO USE THE STEAM IRON
Fill the iron as described in “How to fill with water” section on the instruction manual.
1.
Position the iron vertically and turn the “Temperature control dial” to the steam position.
2. Insert the plug in the power outlet and turn the power on.
3.
Set the “Temperature control dial” to the steam position. Steam ironing is only possible when the
higher temperature settings indicated with “MAX” mark; otherwise the water will leak from the
soleplate.
4. Preheat the iron until the indicator light goes out. The light will turn off when the indicated setting
reaches the correct temperature.
5.
Turn the “Temperature regulating knob” to the required setting for different types of fabric.
Now steam ironing can begin.
Note:
Most tap water can be used for this iron. Do not use water additives or substitute water such as
linen or scented water in the steam iron, they can stain fabrics or damage the iron. Do not overfill the
water more than the “MAX” position
Note:
For optimum steam quality, do not apply more than three successive shots after the indicator
light goes off.
