15 ”
11”
Mounting position
for 3” wide tubes
Mounting position
for 2” wide tubes
Horizontal Movement 5” to 15”
Vertical Movement 15” to 15” Minus Tube Height
Trailer Frame
Long Tube Side Out
Short Tube Side Out
15” max.
5”
mim.
19 ”
15”
Horizontal Movement 5” to 11”
Vertical Movement 19” to 19” Minus Tube Height
Trailer Frame
11” max.
5”
mim.
2” x 4”
Trailer Frame
2” x 4”
Trailer Frame
Guide Post
Placement
Guide
A1406;051216
Page 2 of 2
*Heavy Duty PVC Guide On’s with Lights
Wiring Instructions for Models 86441 & 86440
Trailer
Running Light Wire
(Normally Brown)
Black Wire
(From LED Light)
Splice
Connector
Splice Plate
1. Pull out the white and black wire from the bottom of the
PVC tubes. Straighten both lines to the full length.
2. Position the PVC tubes so the red light faces backward.
While holding the ends of both wires slide the PVC tubes
over the steel support tubes. The remaining wire should
extend below the tube and steel support tube.
3. Press the trailer running light wire (brown) into the open
side of the splice connector. Push the black LED wire
into the opposite side of the splice connector.
4. Place the splice connector in the pliers and press the metal
splice plate thru both wires. Close the locking tab.
5. Place the self tapping screw thru the eyelet on the white
grounding wire. Screw the self tapping screw into the
trailer frame.
6. Hook up the trailer and test your towing lights.
When the trailer/tow vehicle lights are on the red
LED lights should also be on.
Locking
Tab
