Step-N-Safe Extension Ladder Walk-Thru
Installation Instructions
Part ID: 72874
Step 1
Lay the two walk-thru post on flat ground with mounting brackets up.
Slide the tension brackets outward as far as they will slide.
NOTE: The sliding mounting brackets must be arranged on the inner
legs of the ladder.
Step 2
Position the ladder over the ladder walk-thru so the top rung
of the ladder is aligned with the upper mounting brackets.
Lower the ladder into (between) the outer bracket and the
inner tension bracket on both walk through post. Once the
ladder comes to rest on the walk-thru post, slide the ladder
forward as shown in the illustration on the right.
Step 3
Make sure the ladder rungs are flat against the top
portion of each walk through post.
Slide the tension brackets outward making full contact
with the ladder. Working from inside the ladder insert
carriage bolts through the tension bracket and outer
mounting bracket. Attach tension knobs on all four
carriage bolts. Slide the bolt/knob down so that it is
flush against the ladder as shown below. Repeat and
tighten each of the remaining knobs.
Fixed Mounting
Brackets
Sliding
Mounting
Brackets
TIE DOWN
Safety Products Division • 800-241-1806 • 404-344-0000 • www.tiedown.com
