Roof Zone Ladder and TranzSporter Track Anchor
Part #13809
Improve job site safety by securing extension ladders and TranzSporter
tracks sections using the Roof Zone Ladder Anchor. Prevents extension
ladders and track sections from lateral or side to side movement.
Enhance your safety by using in conjunction with Roof Zone #48589
ladder stabilizer/stand-off or TranzSporter #48599 platform hoist
stabilizer.
Roof Zone Ladder Installation Instructions
1. Position ladder according to mfg specifications with a minimum
of 3 ft. above the eave of the roof.
2. With ladder level and at proper angle, climb safely to a level just
above the roof eave.
3. Place strap against the rung, feed the anchor plate through the loop
end so that it captures the rung then tighten snugly. Make sure that
both straps are close to the ladder side rail.
4. Extend ladder strap with anchor plate behind the ladder side rung
to an anchor point on the roof. Locate the nearest rafter to secure
the anchor plate
5. Install a nail or deck screw on the roof decking underneath shingle
tab and into the nearest rafter. Leave head slightly raised so key
slot can slip over.
6. Place anchor plate over nail through the key slot on both straps.
Nail or screw down. Once firmly attached to the roof. Tighten
slack on strap.
For TranzSporter Platform hoists, read manual for proper track set up
and angle. Use extension ladder, do not climb track for installation.
Make sure that the strap stays clear of the carriage at all times by
attaching to the rung, close and under the rails.
TM
Roof Zone is a Division of
TIE DOWN ENGINEERING
www.tiedown.com
255 Villanova Drive SW • Atlanta, Georgia 30336
© 2014 TIE DOWN Inc.
Made in China
TECHNICAL DATA
• Safe Load limit: 50 pounds
• Strap is 1 inch x 34 inches (includes anchor plate)
• Anchor plate has rolled edge to prevent strap wear and zinc plated
for long life.
• Inspect prior to each use for damage, if strap becomes frayed
or cut, discard.
• Use 10 d Common Nail or 3” Deck Screw for securing Anchor Plate.
• Fastener (nail or screw) must solidly penetrate Roof rafter for
assured holding power.
• Buckle is adjustable, inspect prior to each use for proper tension.
• Two strap anchors required per each extension ladder or
track section.
• Check all Federal, State, and local OSHA rules and regulations
prior to use.
