TIDRADIO TD-H5, Руководство по программированию

Страница: 9 / 13

9
Channel Information
The H5 radio has 250 channels, you can edit the channel information according
to your needs. The following is an introduction to each term.
Name Meaning Setting Description
RX Freq Receiving frequency VHF:136-174MHz
UHF:400-520MHz
TX Freq Transmitting frequency GMRS frequency（Fixed）
Name Customize channel
name Up to 6 digits. Support alphanumeric channel na
me.
RX
QT/DQT Receiving CTCSS/DCS Refer to the DCS table and
CTCSS table in the manual. Mutes the speaker of the transceiv
er in the absence of a specific low-l
evel digital signal. If the station you
are listening to does not transmit t
his specific signal, you will not hear
anything.
TX
QT/DQT Transmitting
CTCSS/DCS Refer to the DCS table and
CTCSS table in the manual. Transmits a specific and continuous
sub audible signal to unlock the
squelch of a distant receiver.
W/N Channel bandwidth WIDE/NARROW Wideband (25kHz bandwidth)
narrowband (12.5 kHz bandwidth).
POWER Transmit power HIGH/LOW High power:5W
Low power:1W
PTT-ID When to send the
PTT-ID
OFF does not send
code;
BOT
press PTT button to
send code;
EOT
release PTT
button to send code;
BOTH
press and
release PTT button to
send code
Codes are sent during either the
beginning or end of a transmission.
BusyLock Busy Channel Lockout YES/NO YES: If the channel is occupied,
when you press the [PTT] key on
this channel, the radio will make a
beep tone and will not transmit any
signal.
NO : No matter if the channel is
occupied, the radio will transmit
the signal when you press the [PTT]
key.