Tidal Engineering Synergy Compact, Техническое руководство

Страница: 136 / 346

Synergy Controller Technical Manual, Revision H
Page 136
11.0 EVENTS SCREEN
The Events Screen provides access to the controller’s Inputs and Outputs.
Events Screen
The Events Screen contains the folders for six
Event status folders including the Event Output
folder. These folders are as follows:
♦
Events Outputs
♦
UUT Temperatures
♦
Digital Outputs
♦
Digital Inputs
♦
High Resolution Analog Inputs
♦
Low Resolution Analog Inputs
11.1 Event Outputs
All Synergy Controllers provide the option to control none users on/off outputs called Event Outputs or
Events. These Events can be controlled both in steady state mode and when running programs. In
some cases all of the Event Outputs are available for customer applications and in some cases one or
more Event Outputs are assigned to factory installed features like humidity channel control, GN2
Purge or Chamber Light. For example, test engineers can use these Event Outputs to enable/disable
power to the Unit-Under-Test (UUT) for certain portions of a profile, enable LN2 solenoids or operate
some special test equipment.
Each Event Output can be controlled while the chamber is running in manual mode or
programmatically from the program. See the Programming Section 9.0 of this manual for additional
information regarding the Setpoint Step. The On/Off state of each Event can be monitored in the
Events\Event Output folder. The LED is red when the event is On and gray when it is Off.
Event Outputs
In the Manual (Steady State) mode, Events 1
thru 9, the Drier, and LEV 2 can be switched On
and Off. When Event 1 thru 9 is pressed, a
checkmark appears in the box. Press
Apply to
apply the state of each Event check box to the
outputs. .
Select All and Unselect All buttons are
provided for Events 1 thru 9.
In the Run Mode, this screen serves as a status
screen. The LED indicators turn red when the
Event is On and grey when the Event is Off.