Tico Pro-Spotter, Руководство по обслуживанию

Страница: 84 / 211

4-16 Service Manual
TICO Manufacturing
ENGINE PRO-SPOTTER
SURGE TANK
Removal
1. Park and prepare tractor for service. (See “Park
Tractor Safely” on page 1-3.)
2. Disconnect battery cables. (See “BATTERY” on
page 3-3.)

CAUTION
3. Drain cooling system into a suitable container. (See
“Cooling System Draining” on page 4-14.)
Figure 4-25: Surge Tank
4. Disconnect electrical connector (2).
5. Install identification tags and disconnect hoses (3,
4,10, and 12). Close all openings using caps and
plugs.
6. Remove lock nuts (7), washers (6), and cap screws
(8).
7. Remove surge tank (1).
Inspection
• Check hoses, fittings, and clamps for wear or
damage. Replace parts found to be unserviceable.
• Inspect surge tank and filler cap for damage or signs
of leakage. Repair or replace parts found to be
unserviceable.
• Check all threaded components for damaged or
stripped threads. Repair light damage with thread
chasers. Replace parts found to be unserviceable.
• Check wiring harness
for wear or damage.
Replace
parts found to be unserviceable.
• Clean all parts of dirt and debris.
Installation
Installation is reverse of the removal procedure.
• Properly fill the cooling system with recommended
coolant. See the Cummins™ Operation and
Maintenance Manual for more information.
• Operate the engine and check for leaks.
Avoid injury and serious burns from escaping
cooling system fluid under pressure. Stop engine
and allow cooling system temperature to reach
50°C (120°F) or below. Slowly loosen filler cap to
relieve pressure.
Specifications
Cooling System—Capacity
53 L
14 gal
1 Surge Tank 7 Lock Nut (4 used)
2 Electrical Connector 8 Cap Screw (4 used)
3 Engine-to-Surge Tank Hose 9 Hose Clamp (2 used)
4 Overflow Hose 10 Radiator-to-Surge Tank Hose
5 Filler Cap 11 Hose Clamp
6 Washer (4 used) 12 Surge Tank-to-Frame Coupler
Hose
10
TPS-019
5
4
3
11
12
8
6
7
9
1
2
9