Tico Pro-Spotter, Руководство по обслуживанию

Страница: 165 / 211

PRO-SPOTTER CAB
TICO Manufacturing
Service Manual 13-11
CAB TILT CYLINDER
Removal
See Figures 13-17 and 13-18.
1. Park and prepare tractor for service. (See “Park
Tractor Safely” on page 1-3.)
Figure 13-17: Lock Bar
2. Raise cab completely and allow it to settle into detent
position 1 (full open) (1) of the lock bar (4).

CAUTION
3. Press the cab lower button again to reduce cab tilt
hydraulic pressure on the cab tilt cylinder (5).
Figure 13-18: Cab Tilt Cylinder
4. Install identification tags and disconnect cab tilt
pump-to-cab tilt cylinder hydraulic line (9). Close all
openings using caps and plugs.
5. Remove roll pin (6).
6. Using appropriate lifting device, support cab tilt
cylinder.
7. Remove cylinder pin (7) and spacers (8).
8. Remove roll pin (10).
9. Remove cylinder pin (12), spacers (11), and cab tilt
cylinder.
10. Repair or replace components as necessary.
1 Detent Position 1 (full open) 4 Lock Bar
2 Detent Position 2 (half
open) 5 Cab Tilt Cylinder
3 Detent Position 3 (minimum
open)
Avoid personal injury from high-pressure fluid.
High-pressure release of oil from a pressurized
system can cause serious burns or penetrating
injury. Relieve pressure from cab tilt hydraulic
system before servicing.
TPS-083
1
2
3
4
5
5 Cab Tilt Cylinder 9 Cab Tilt Pump-to-Cab Tilt
Cylinder Hydraulic Line
6 Roll Pin 10 Roll Pin
7 Cylinder Pin 11 Spacer (as required)
8 Spacer (as required) 12 Cylinder Pin
5
TPS-084
7
8
6
9
12
10
11