TIC GS-3, Инструкция по эксплуатации, Страница: 9 / 12

7
Installation/Maintenance Note
•
The GS speaker can be installed in-ground or surface-mounted. In-ground installation is generally optimal since
burying speaker in-ground will enhance its resonance, providing a fuller audio experience. When mounted on a
surface, please ensure the wiring is safely secured and does not become a tripping hazard.
•
For in-ground installation, only burial-grade insulated speaker wires should be used. Conduit can be used
alternatively in conjunction with standard speaker wires. Wire/conduit should be buried 4-
6” below ground.
•
For connecting/extending speaker wires, we highly recommend using waterproof wire connector (ie. SPC-CN1).
Alternately, silicon can be applied to the opening of standard wire nut to provide water protection.
•
The GS series is designed to be water-resistant not waterproof. When burying the
speaker in-ground, the bottom of the grill should be at least 2 inches above ground level.
In addition, speaker should not be installed in a low area prone to water collection or
where sprinklers will spray into the grill. During heavy snow season where snow fall
level will be higher than the grill, speaker should be covered by a plastic tarp so that
melted snow will be diverted away from the speaker driver. The GS speaker is designed
to be protected against rain and snow fall but not water submersion.
•
System should be fully tested above surface before speakers and wires are buried.
•
If sound is muddled or multiple speakers are not in sync, please check to ensure wire polarity is correct.
•
To clean speaker, you can rinse with fresh water from directly above the speaker and wipe with a cloth. If
needed, use mild detergent to remove dirt. Do not spray water directly into the grill. In addition, the driver can
be wiped with a damp cloth and foam ring can be rinsed (or replaced) periodically by removing the top cover.