Camera Site
Connect the Terminal No.5
——⑤
in terminal block for data connection to Left Track of
audio source (CD player, Microphone, etc.), and Terminal No.6
——⑥
is used for
ground connection; Connect the Terminal No.7
——⑦
in terminal block for data
connection to Right Track of audio source (CD player, Microphone, etc.), and Terminal
No.8
——⑧
is used for ground connection.
Control Site
Connect the Terminal No.5
——⑤
in terminal block for data connection to Left Track of
speaker (sound box, etc.), and Terminal No.6
——⑥
is used for ground connection;
Connect the Terminal No.7
——⑦
in terminal block for data connection to Right Track
of speaker (sound box, etc.), and Terminal No.8
——⑧
is used for ground connection.
Indicator LEDs
The stand-alone units have integral LEDs that are used to monitor the state of the unit.
There are one video LED, one power LED and four data LEDs on each unit. One,
labeled as “PWR”, lights when operating power is present. Another, labeled as “VID”,
lights when the video input/output signals are detected. The other one, labeled as
“DATA 1, DATA 2, DATA 3, DATA 4”, among them “DATA 2, DATA 3, DATA 4” are
normally on (unavailable), and “DATA 1” blink at the rate of the operating data. As
shown in the diagram in the following,
TRANSMITTER and RECEIVER:
Power:
ON: (Orange) Indicates that correct power has been applied
Transmitter:
Video: OFF: Indicates no video detected on input BNC connector
(No Video present on input BNC)
ON: (blue) Indicates video detected on input BNC connector
(Video present on input BNC)
６
