P a g e
|
3
Questions? Contact Customer Service @ 402-435-4249
4. On the keypad controller press and hold the
program button (small button), then press and hold
the large
“
Open
”
button simultaneously. Release
both buttons when the status LED turns solid green.
The LED will then flash orange rapidly which
indicates it is ready to receive remote programming.
See Fig 2.1.
5. On the first remote, press and hold the
“
On/Open
”
button until the LED on the keypad blinks green
rapidly for 2 seconds then turns solid white.
Release the button and keypad should then start
blinking orange to accept additional remotes.
6. Repeat step 5 until the desired amount of remotes
(no more than 4) are programmed. The LED will
blink red two times once programming has been
completed or will go back to regular operating mode
after 10 seconds of inactivity. Pressing the
programming button will also exit programming
mode.
The control box resets the list of remotes it remembers every time you enter the programming mode to program a remote.
Remotes that were previously programmed are removed from the control box memory and will no longer be able to control
the system. This is why all remotes need to be programmed at the same time.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
This device complies with Industry Canada licence-exempt RSS-xxx standard. Operation is subject to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
BLOCKING FUNCTIONS ON REMOTE (Optional)
This function allows modes to be blocked if not used
.
1. Open flip style lid. Observe the flashing light.
2. Press and hold the
“
Mode
” button for 10 seconds until light 1 stays on.
3.
Press the “
On/Open
” button if the lit function will be used. Press the “
Off/Close
” button if you want
this function to be blocked out.
4. Repeat Step 3 for all five functions.
a. 1 LIGHT -
TARP SYSTEM
b. 2 LIGHTS -
FRONT HOPPER
c. 3 LIGHTS -
REAR HOPPER
d. 4 LIGHTS -
AUXILIARY
e. 5 LIGHTS
WORK LIGHTS
5. When the last function has been selected, the light on the first mode function will stay lit for
approximately 3 seconds to indicate activation and return to flashing when process is complete.
6. When selecting modes, only the ones selected to be
“On”
will function.
Off/Closed
Button
On/Open
Button
MODE
Lights
Fig. 3.1
Mode
Selection
Button
