Thundercomm TurboX C610 Open Kit
Rev. 1.0
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION
8
2
Program the Firmware
The following method is the recommended procedure for downloading your
experimental version of self-compiled OS on C610. A host PC is needed to
program the board.
The procedure for both Windows and Linux host systems is described.
2.1
Program system images using Fastboot
NOTE:
Ensure you have installed the required ADB and Fastboot drivers. Your board
must be detected on your host machine.
To install Linux from a host PC complete the following steps:
1.
Download the C610 fastboot images package from the Thundercomm website
and unzip it.
2.
Entering to Fastboot
a.
Press and hold ‘VOL-’ then press Power once quickly to force the device
to enter Fastboot mode
b.
Alternatively “adb reboot bootloader” from the command prompt.
3.
Plug the USB cable into the Device
“QCS610 USB 0”
4.
Confirm that Fastboot is active as follows:
a.
From the Windows command shell, run:
fastboot devices
dae93bbb
fastboot
b.
From Linux, run:
$sudo fastboot devices
dae93bbb
fastboot
