10
BEFORE SETUP
TO PREVENT SERIOUS INJURY FROM EXPLOSION:
Use only clean, dry, regulated, compressed air to power
this tool. Do not use oxygen, carbon dioxide, combustible gases, or any other
bottled gas as a power source for this tool.
1. Incorporate a filter, regulator with pressure gauge, in-line shutoff valve, and quick
coupler for best service,
An in-line shutoff ball valve is an important
safety device becauseit controls the air supply even if the air hose is
ruptured. The shutoff valve should be a ball valve because it can be
closed quickly.
Note:
Do not use an automatic oiler system or add oil to airline. The oil will con-
taminate the material being propelled, ruining the final result.
2. Attach an air hose to the compressor’s air outlet.
3. Connect the air hose to the air inlet of the tool. Other components, such as a
coupler plug and quick coupler, will make operation more efficient, but are not
required.
WARNING! TO PREVENT SERIOUS INJURY FROM
ACCIDENTAL OPERATION:
Do not install a female quick coupler on the tool. Such
a coupler contains an air valve that will allow the air tool to retain pressure and
operate accidentally after the air supply is disconnected.
Note:
Air flow, and therefore tool performance, can be hindered by undersized air
supply components.
4. The air hose must be long enough to reach the work area with enough
extra length to allow free movement while working.
5. Close the in-line shutoff valve between the compressor and the tool.
6. Turn on the air compressor according to the manufacturer’s directions and
allow it to build up pressure until it cycles off.
7. Open the in-line shutoff valve.
8. Adjust the air compressor’s output regulator so that the air output is enough
to properly power the tool, but the output will not exceed the tool’s maxi-
mum air pressure at any time. Adjust the pressure gradually, while checking
the air output gauge to set the right pressure range.
9. Inspect the air connections for leaks. Repair any leaks found.
10. If the tool will not be used at this time,turn off and detach the air supply and
safely discharge any residual air pressure to prevent accidental operation.
Содержание H827C
Страница 2: ...2...
