4
a. Install the antenna into transmitter
b. Check the frequency printed on the transmitter crystal.
c. Check the frequency printed on the RS ESC/Receiver module and crystal. Make sure
it matches with the transmitter crystal. Make sure no one will operate on the same
frequency when you are. When there is a radio glitch, it will most likely be caused by
improper crystal, damaged crystal, or people operating on the same frequency.
a. Install 8 AA size alkaline batteries into the transmitter.(Make sure the correct polarity order)
b. Install supplied power pack into the batter holder. And then secure the battery holder
under the battery cover plate and RS ESC/Receiver module by using a small "R" clip.
c. Connect the plug harness of the battery with the RS ESC/Receiver module.
a When turning radio on, first turn on the transmitter.
b. Then, turn on the receiver. When turning off, first turn the receiver off, then the
transmitter off. It's an important hint to prevent unexpected damages.
c. To reverse the functions of servos, use the small, white servo reverse switches located on side
of the pistol transmitter. To trim the servos on the pistol transmitter, use the trim switches on
side of the steering wheel (the ST. trims steering, and the TH trims throttle/brake). On a stick
transmitter, the trim levers are located accordingly around the sticks.
Frequency interference
Never operate the transmitter without checking your radio frequency, or you may create
interference to other modeler.
1
Step
PREPARING THE RADIO
2
Step
BATTERY INSTALLATION
3
Step
RADIO OPERATION
OPERATION
a
a
b
b
c
c
a
a
b
b
c
c
a
a
b
b
c
c
Содержание ZK2
Страница 8: ......
