Thump TSK50cc, Руководство пользователя

Страница: 51 / 132

47
Engine Oil
CHANGING ENGINE OIL
1. If the engine is cold, start it and let it idle for 3-5 minutes. Turn the
engine off. Wait 2-3 minutes for the oil to settle.
2. Park your motorcycle on a firm, level surface.
3. Remove the oil fill cap/dipstick.
4. Place a drain pan under the crankcase.
5. Unscrew and remove the oil drain bolt .
6. After most of the oil is drained, gently tilt the motorcycle from side to
side to drain the remaining oil.
7. Pour the drained oil into a suitable container and dispose of it in an
approved manner.
8. Remove the old sealing washer and install a new sealing washer
on the drain bolt.
9. Install the oil drain bolt and tighten to the specified torque:
18 lbf·ft (24 N·m , 2.4 kgf·m)
10. Pour the recommended oil into the crankcase, approximately:
1.1 US qt (1.0 )
11. Install the oil fill cap/dipstick securely.
12. Start the engine. Let it idle 3-5 minutes, then turn it off.
13. With the motorcycle held upright on level ground, check the oil level.
If needed, add oil until it reaches the upper level mark. (Do not overfill.)
14. Check for oil leaks.
Washer
Oil Drain Bolt