10
•
Wrinkles lead to overheating and can be dangerous.
•
Place the bottom sheet on the electric bed warmer that should be smooth without wrinkles.
OPERATION.
•
Connect the controller to the electric bed warmer.
•
Make sure there is a plug nearby, and that when it is in use, the cable is not in a position that
can cause people to trip over him.
•
When plugged into the electrical power, the controller must be visible and accessible.
•
Do not cover the controller and do not put pressure on it by putting things on top or covering
it.
•
Preheat before using or before going to bed.
•
For preheating, select the highest temperature "3” for 30-60 minutes maximum.
•
During use you can select the desired temperature between "1-3".
•
If you use it while you sleep, it is advisable to set the lowest temperature "1" avoiding
discomfort of the body due to excess heat and to avoid the risk of overheating.
AFTER USE
.
•
When the electric bed warmer is not in use, set the controller to the "0" off position.
•
Remove the plug from the socket.
•
Do not pull the cable to disconnect it from the mains, grab and pull of the plug.
•
If you do not use the electric bed warmer for an extended period, store the electric bed
warmer in a cool and dry place.
Hold the socket with one hand and
push the controller plug until the
locking tab is over the plug on top of
the controller plug.
- To remove the driver, lift the locking tab
with your finger and pull the plug straight out.
- Do not pull on the contro ller cable and do not try to
remove the controller connector without lifting the tab
blocking, as it will damage the plug.
