___________________________________________________________________________
page 23
However, intermediate settings made “on the fly” will be maintained for each
surround mode until the AV100/120 is turned off or set into standby.
6.9 Return to factory default setting
Each setting in the configuration menu will be stored even if the mains power is cut
off.
However, if your entire set-up does not work satisfactorily, it may be desirable simply
to reload the original factory default settings, like rebooting a computer.
If this option is selected by the ”
⇒
” key, the user will be asked
SURE ?
in the
display. If accepted, the user must then press the “ENTER” key. Otherwise, cancel
the changes by pushing “
⇐
” or “>VOL”.
Please note that delay and volume trim settings will be returned to their original
settings with this command and your personal settings cannot be restored.
6.10 OSD
(Only applicable for AV100S and AV120S.)
The information on the front panel display can also be displayed on the TV-set or
projector (On Screen Display) by the built-in video encoder.
When entering the config menu, a full-screen OSD is enabled, which overrides other
video sources.
In normal mode, the OSD is mixed with the selected video signal.
The following settings are possible:
- OSD is disabled
- OSD is enabled only by commands from the remote control (factory setting)
- OSD is enabled both by command from the remote control and front panel keys
When no OSD is displayed, the OSD circuit is automatically switched out of the
video signal path to obtain maximum video quality from the sources.
6.11 SPDIF OUT
In this menu you can select which channels should be sent to the optical digital
output.
The sample rate will change according to the different sources used, e.g. analogue
input and DTS 96kHz has an output of 96kHz, while normal DVD output is 48kHz.
6.12 Power Amp control
The AV100/AV120 can control an external Thule Audio amplifier via the rear RJ45
connector. When using IA350, PA350 or PA250 MKII for L & R power amplification
in an 8.1 system (see “Side Channels” in “Surround mode” section), the AV100/120
should be set in “FIXED 2 CH CONTROL” and signal from SSL, SSR processor
should be redirected to the built-in L & R power amplifiers by setting “L,R processor”
-> SSL, SSR power.
In this case, it is also necessary to connect a special RCA/phono-to-XLR cable
between the AV100/120 and the IA/PA350B amplifiers, because the IA/PA350B
amplifiers will always use the balanced input in two-channel mode when controlled
externally by the RJ45 connection.
Содержание SPHERE AV100
Страница 2: ......
