Figure 3
7
WARNING
To avoid possible
fi
re or shock, be sure electricity is
turned off at the main fuse box before wiring.
(Figure 2)
Figure 4
WARNING
Check to see that all connections are tight, including
earth, and that no bare wire is visible at the wire
connectors, except for the earth wire. Do not operate
fan motor for long periods unless the blades are in place.
1.
Securely connect the green/yellow earth wires from the
hanger ball and the hanger bracket and the supply
green/yellow earth wire to the terminal block as shown in
Figure 3.
2.
Securely connect the blue fan motor wire and the black
supply neutral to the “N” terminal of the connector block
as shown in Figure 3.
3.
. Securely connect the red light wire and the wire from
light switch to the “L1” or light symbol terminal of the
Securely connect the brown fan motor wire and the
wire from the wall control to the "L" terminal on the
connector block as shown in Figure 3.
1.
With electrical power still disconnected, route fan
(and light) wiring to desired location on wall.
2.
Ensure wiring connections are as shown in Fig 3. The
Active (Red) supply wire must be connected
to terminal "C" on the rotary switch. Return switched wire
t ce l ng fan t be c nnected fr m term nal 3 n the r tar
s tch t
term nal n the c nnect r bl ck.
3.
Fit the wall control (rotary) switch to a face plate (not
supplied) and attach to wall.
INSTALLATION NOTE:
The “O” and the small corner
cut-out on the front of the switch mechanism must be at
the top and top left respectively (See Figure 4).
4.
Restore electrical power by turning on the
electricity on at the main fuse box.
5.
Check the operation of the fan by rotating the control
through the four positions marked 0 - III
(“0” position is OFF) (Figure 5).
6.
All fans are shipped from the factory with the reverse
switch positioned to circulate air downward.
If airflow is desired in opposite direction, turn your fan
OFF and wait for the blades to stop turning,
then slide the reversing switch to the opposite position,
and turn fan on again.
Figure 5
= OFF
= FAST
= MED
= SLOW
After connections have been made, carefully push wires
into the recess making sure there is separation between
conductors and cover joiners with PV
V
C tape.
INSTALLATION NOTE:
If light fixture is NOT required,
insulate the unused wires and restrain them.
Red Wire
(Light Active)
Fan Speed Control
Light Switch (not supplied)
Fan Speeds: 3 = High, 2 = Medium, 1 = Slow
connector block as shown in Figure 3 (if applicable).
The light (if fitted) can be
wired to an ordinary light switch (not supplied). The fan
and light must be fed from the same incoming supply.
Home automation and complex switching systems must
ensure the active and neutral come from the same circuit to
avoid problems with safety switches or shock hazards.
Isolating
Switch
**
** Refer to wiring rules and product standards for isolation switch requirements.
