Thrax Audio Libra, Руководство по эксплуатации

Страница: 11 / 12

11
For initial power up press the main switch located on the back panel.
To switch the preamplifier on press & hold the Left Knob on the front panel or the ON/OFF
button on the remote control - allow the tubes to warm up for approx. 30 seconds.
The front panel display will be on while the unit is executing a command and then turns
off after a short timeout period , which can be customized in the System Settings menu.
To turn the preamplifier off press & hold the Left Knob again, or use the remote . All the
amplifier circuitry will be turned off for minimum power consumption leaving only a small
STANDBY circuit running. However if you are not going to use the amplifier for a long
period we recommend turning it off, using the power switch on the back panel, to save
power.
Refer to pages 7-9 of this manual for using the Menu.
As with all high fidelity products, the sound characteristic changes somewhat as it warms
up. Best sound will be achieved after about 15 minutes of operation.
Any time that the Libra Preamplifier has not been used for a few weeks the sound may be
different. This is also normal for high resolution audio equipment. Optimum sound should
return after a few hours of operation, preferably with an audio signal.
Note that although your Thrax Audio System has been run for 72 hours at the factory, it will
continue to ”break in” for approximately 150 hours. Also be aware that many
components display the need for a new break in period after being transported in
unheated cargo aircraft.
OPERATION