Thrane&Thrane TT-3080A, Руководство пользователя, Страница: 61 / 124

Pointing the antenna Pointing the antenna Pointing the antenna Pointing the antenna Getting started Getting started Getting started Getting started
7Sep01 7Sep01 7Sep01 7Sep01 Page Page Page Page 4-23 4-23 4-23 4-23
2. 4 wire Antenna Power Cable. Insert Hirose connector in
antenna.
• Connect brown wire to Ant power connector 1
• Connect black wire to Ant power connector 2
• Connect yellow/green wire to Ant power connector 3
• Connect blue wire to Ant power connector 4
3. RF coax antenna cable. Insert QLA connector in M4 terminal
and TNC connector in antenna.
4. 2 wire BDE Power Connector. Insert DC connector in M4
terminal.
•
Connect brown wire to BDE power connector 1
•
Connect blue wire to BDE power connector 2
5. Handset cradle cable. Disconnect handset from M4 terminal.
Connect handset to cradle. Connect cradle cable to connector
on the bottom of M4 terminal.
6. Single white wire. Can be connected individually to power up
the antenna in several ways, e.g., before ignition, after ignition
but before engine start or only when the engine is running. The
power-supply is tuned on when the CMD input goes high.
• Connect one end to Input power connector 3 (CMD)
•
Connect other end to preferred point on ignition switch.
7. Connect handset cable to handset cradle.
Notes:
Notes: Notes:
Notes:
• The magnetic mounts may be used on a mild steel surface,
thicker than 2mm. When using the magnetic mounts, do not
exceed a vehicle speed of 110km/h, as the wind drag
resulting from higher speeds may cause the antenna to come
loose from the vehicle.
•
The antenna radiates RF signals during a call, therefore a
safety distance must be observed). Allow a passage distance
of approx. 2 meters from the antenna. The radiated signal is
strongest on the focal line of the antenna and drops off
quickly!