MARINE SSAS
8
GPSDK/T
T SSAS C
onfi
g
. 1A-300904
5. SHIP SECURITY ALERT MESSAGE CONFIGURATION
IMPORTANT NOTICE: The recipient of a SSA Message is defi ned according the vessel’s ISPS Code as well as its Flag
State.
1) Some ISPS Codes or Flag States demands DIRECT SSA Messaging. If this is the case the specifi c SSA Message destina-
tion address must be programmed in the TT-3000SSA.
2) Other ISPS Codes or Flag States accepts SSA Messages that is relayed by a Competent Authority. LocPoint Marine
SSAS can act as a Competent Authority by retrieving and redistribute incoming SSA Messages to third parties, including
the recipient as specifi ed by the ISPS Code or Flag State.
5.1.
SSA MESSAGE SET-UP INTRODUCTION
The TT-3000SSA can be programmed to transmit SSA Messages DIRECTLY to three different recipients. Each recipient is
confi gured as ENTRIES, from entry 0, 1 or 2 (see TT-3000SSA Installation Manual).
In case of situation 1 above)
Entry 0 will be programmed with the destination address of the ISPS Code or Flag State.
Entry 1 and 2 can be programmed according your (customer’s) choice, i.e. via LocPoint.
In case of situation 2 above)
Entry 0 will be programmed with the destination e-mail address of LocPoint.
Entry 1 and 2 can be left empty, as the redistribution parameters can be confi gured on LocPoint website.
5.2.
SET LES USED TO TRANSMIT SSA MESSAGES
Syntax:
Se -m <LES AORW>,<LES AORE>,<LES POR>,<LES IOR>
Command Example:
:
se -m 4,104,204,304
* Check:
:
se -m all_oceans
Land Mobile Alert LES for ocean 0 : 4
Land Mobile Alert LES for ocean 1 : 104
Land Mobile Alert LES for ocean 2 : 204
Land Mobile Alert LES for ocean 3 : 304
5.3.
SET SSA MESSAGE RECIPIENT TO LOCPOINT
Syntax:
Se -am <Entry>,<Type>[,<Addresses>[,<Param>]]
Command example:
:
se -am 0,254,[email protected]
* Check:
:
Se -am
Update time: 2004-09-21 09:20:35
Entry Type Param Address
0 254 [email protected]
1 Address not used
2 Address not used
To set/clear addresses: se -am <Entry>,<Type>[,<Addresses>[,<Param>]]
5.4.
SET OTHER SSA MESSAGE RECIPIENTS
Please consider paragraph 1) and 2) in section 5.1.
*********
Version 1.00
